Model Y Tow Package

When using the tow package to carry accessories, the 2 x 2 inch (5 x 5 centimeter) square hitch receiver is designed to support vertical loads of up to 160 pounds. The Model Y Tow Package comes with:

1 x high strength steel tow bar with 2" hitch receiver and North America 7-pin standard connector
1 x trailer harness
1 x tow mode software package

Ball mounts are not included and are dependent on the type of trailer you are towing.

Frequently Asked Questions Show All Hide All

You will first need a ball mount. Compatible ball mounts must be purchased separately based on the type of trailer you are towing. The Model Y hitch receiver supports a ball mount with a length of up to 8.5 inches (22 centimeters) and a raise of up to 0.75 inches (2 centimeters).

Note: Ball mounts that do not meet these requirements cannot be used. Refer to your owner’s manual for more information.

Start by attaching the ball mount. To attach a ball mount, follow these steps:
1. Remove the dust cover from the hitch housing by using a small object, such as a flat screwdriver, to carefully pry between the dust cover and hitch housing. Store the dust cover in a secure location.
2. If needed, remove the cotter pin from the locking bolt and slide the locking bolt out of the hitch assembly.
3. Align the hole in the ball holder with the one in the hitch assembly.
4. Slide the locking bolt through the hitch assembly or ball holder.
5. Insert the cotter pin in the hole at the end of the locking bolt.
The driver is responsible for ensuring that the trailer is equipped with any features and functionality required by law, including but not limited to, taillights, brake lights, side marker lights and turn signals. To power the trailer lighting, a built-in 7-pin standard wiring connector is available near the hitch. This supports most types of trailers. Adapters for other types of connectors can be purchased separately. Plug the trailer wiring into the Model Y electrical connector to automatically engage Trailer Mode.

Note: It is the driver’s responsibility to ensure that all electrical connections are working and all trailer lights are operating before and during towing. You must perform manual checks. Refer to your owner’s manual for more information.
To remove a ball mount, follow these steps:
1. Remove the cotter pin from the locking bolt and slide the locking bolt out of the hitch assembly or ball assembly.
2. Pull the ball holder out of the hitch assembly.
3. Reinstall the dust cover for the hitch housing and store the ball mount in a secure location.
Trailer Mode must always be active when towing a trailer.

While in Trailer Mode, the following features operate differently:
1. Traffic-Aware Cruise Control increases the following distance from the vehicle in front of you.
2. Side collision warnings are active but automatic steering interventions are disabled.
3. The braking force provided by Automatic Emergency Braking may be limited. Therefore, stopping distance may increase.
Note: Some Autopilot features such as Autopark and Autosteer, as well as rear parking sensor functionality, may not be available when Trailer Mode is enabled. Refer to your owner’s manual for more information.
When you connect a trailer’s electrical connection while the vehicle is in Park, Model Y automatically enables Trailer Mode. Disconnecting the trailer’s electrical connection does not automatically disable Trailer Mode. Trailer Mode can be manually enabled or disabled from your touchscreen by selecting ‘Controls’ > ‘Pedals & Steering’ > ‘Trailer Mode.’ Trailer Mode must always be enabled when towing a trailer.