Replacing a Wall Connector

Replacing an existing Gen 3 Wall Connector is an easy process that does not require a Tesla Certified Installer - all you need is the replacement Wall Connector, your mobile device and a screwdriver. To ensure you have a Gen 3 Wall Connector, check the part number on the side label, which will be displayed as TPN: 1457768-##-#.

To replace a Wall Connector, follow these steps:

  1. Turn off the circuit breaker.
  1. Remove the four screws holding the Wall Connector onto the wire box (two top, two bottom).
  1. Pull the original Wall Connector off the wire box.
  1. Remove the replacement Wall Connector from the box.
  1. Place the new Wall Connector onto the existing bracket.
  1. Secure in place with the four screws (two top, two bottom).
  1. Turn on the circuit breaker.
  1. Connect to Wi-Fi and finish setup.
Additional Resources

Back to Top

In This Article